Sears N9MP1125J20B1, N9MP2050B12B1, N9MP2080F16B1, N9MP2075B12B1 440O1102004, Clearance Description

Item Clearance Description

AClearance above grade, veranda, porch, deck, balcony, or anticipated snow level

BClearance to a window or door that may he opened

Canadian Installation (1)

12" (30cm)#

6" (15 cm) for appliances _< 10,000 BTUH (3kW), 12" (30 cm) for appliances > 10,000 Btuh (3 kW) and _<100,O00 Btub (30 kW), 36" (91 cm) for appliances > 100,000 Btab (30 kW)

U.S. Installation (2)

12" (30cm)

6" (15 cm) for appliances_<10,000BTUH(3kW),9" (23 cm) for appliances>10,000Btuh(3 kW)and _<50,000Btuh(15 kW),12" (30cm) for appliances>50,000Btub(15 kW)

CClearance to a permanently closed window

DVertical clearance to a ventilated soffit located above the

terminal within a horizontal distance of 2'(61cm) from the centedine of the terminal

EClearance to an unventilated soffit

FClearance to an outside corner

O	Clearance	to	an inside		corner
H	Clearance	to each side			of the	centedine	extended above	3'(91 cm) within 15' (4.5 m) above the meter/regulator
	electrical	meter		or gas	service	regulator	assembly	assembly
I	Clearance	to	service regulator			vent outlet		3'(91 cm)
J	Clearance	to	non-mechanical			air supply	inlet to building or	6" (15cm)forappliances_<lO,OOOBTUH(3kW),9" (23cm)
	the combustion			air inlet	to any	other appliance		for appliances> 10,000Btah (3kW) and _<100,000Btah(30
								kW) and _<50,000Btuh(15kW), 12" (30 cm) for appliances
								> 50,000Btah(15kW)

3'(91 cm) within 15' (4.5 m) above the meter/regulator assembly

6" (15cm)forappliances_<lO,OOOBTUH(3kW),9" (23cm)

for appliances > 10,000 Btah (3 kW) and _<50,000 Btuh (15 kW), 12" (30 cm) for appliances > 50,000 Btuh (15 kW)

K	Clearance	to a mechanical	air supply inlet		6'(1.83m)		3'(91 cm) above if within 10' (3m horizontally)
L	Clearance	under a veranda,	porch, deck,	or balcony	12"	(30 cm)	+
M	Clearance	to each side of the centerline		extended above or	12"	(30 cm)	12" (30 cm)
	below vent terminal of the furnace to a dryer or water heater
	vent, or other appliance's direct vent intake or exhaust.
N	Clearance	from a plumbing	vent stack		3'(91 cm)		3'(91 cm)
(1.)	In accordance wifh the currem CSA B149.1, Natural Gas and Propane Installation Code
(2.)	In accordance	with the current ANSI Z223.1/NFPA 54, National			Fuel Gas Code

#18" (46 cm) above roof surface

+ Permitted only if veranda, porch, deck, or balcony is fully open on a minimum of two sides beneath the floor.

For clearances not specified in AN SI Z223.1/N FPA 54 or C SA B149.1, clearances shall be in accordance with local installation codes and the requirements of the gas supplier and the manufactare's installatio i instructions.

Notes:

1. The vent for this appliance shall not terminate a. Over public walkways; or

b. Near soffit vents or crawl space veins or other areas where condensate or vapor could create a nusiance or hazard or property damage; or c. Where condensate vapor could cause damage or could be detrimental to the operation of regulators, relief valves, or other equipment.

2. When locating vent terminations, consideration must be given to prevailing winds, location, and other conditions which may cause recirculation of the combustiob products of adjacent vents. Recircula0on can cause poor combustion, inlet condensate problems, and accelerated corrosion of the heat exchangers.

440O1102004 E_