32 Chapter 3 Setting Up and PuttingAway the System GEInspection Technologies XLG3 VideoProbe System
Putting the System Away
To Put the System Away
1. Press and hold the button just below the joystick.
The bending neck straightens.
2. If any storage devices are in place, use the Eject
Hardware menu command and then remove them.
3. Turn off the power switch, and disconnect power cord from the power source.
4. Detach any peripheral devices or accessories.
5. Remove the optical tip, and install the head guard.
6. Remove the handset and its holder.
a. Pull up on the handset, slightly twisting in either direction until it comes free.
b. Push the release button, and pull up on the holder.
7. Store the insertion tube in the base unit’s internal storage reel.
a. Straighten any loops or twists in the insertion tube.
b. Feed the insertion tube as far as it goes into the funnel.
c. Place the handset face-down in the base unit’s handle.
Caution Before removing storage devices, you must use the Eject
Hardware menu command. For details, see “To Eject a Storage Device Other
than DVD” on page 76.
Caution The head guard prevents damage to the tip attachment
mechanism. Keep the head guard on whenever no optical tip is in place.
Hold this button.
Everest XLG3
Home
ba
b
c