Sennheiser 500 Series Switching the devices on/off

Using the devices

w500 G3

00MHz

KM500

If you cannot establish a transmission link between transmitter and receiver:

Make sure that transmitter and receiver are set to the same frequency bank and to the same channel.

If necessary, read the chapter “If a problem occurs ...” on page 30.

It is vital to observe the following notes:

Make sure that the desired frequencies are listed in the enclosed frequency information sheet.

Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

EM 500 receiver

To switch the receiver on:

Briefly press the STANDBY button .

The receiver switches on and the “Receiver Parameters” standard display appears.

To switch the receiver to standby mode:

If necessary, deactivate the lock mode (see page 22).

Keep the STANDBY button pressed until “OFF” appears on the display panel.

When in the operating menu, pressing the STANDBY button will cancel your entry (ESC function) and return you to the current standard display.

To completely switch the receiver off:

Disconnect the receiver from the mains by unplugging the mains unit from the wall socket.