Putting the receiver into operation
Mounting the antennas to the front of the rack
When rack mounting the receiver, you require the GA 3030 AM antenna mount (available as an accessory) to mount the antenna connections to the front of the rack. The GA 3030 AM antenna mount consists of:
y2 BNC extension cables
y2 antenna holders Z
y4 screws
y2 washers Y
y2 nuts X
Unsecure the rack mount “ears” 1from the rack.
Guide the BNC cables through the holes in the rack mount “ears” as shown in the diagram on the left.
Screw the antenna holders Zto the BNC sockets Yusing the supplied washers X and nuts W.
Secure the antenna holders Zto the handles of the receiver using two of the supplied screws respectively.
Connect the two BNC connectors [to the BNC sockets Oand Rat the rear of the receiver.
Slide the receiver into the 19’’ rack.
Resecure the rack mount “ears” 1 to the rack.
Connect the antennas \to the BNC sockets W.
Align the antennas upwards in a
15