Sennheiser EM 3732, EM 3731, EM 3732 Command 30

The operating menu

Tune

B.Ch 790.

U.01 800

MHz

776 866

UHFMHz

DEV	M	save digital audi
	790.800 z	processing
	H	processing
	03.03CH	sync
	BANK AF COM	esc

sync

B.Ch

790.800MHz 1.

DEV	M	save digital audi
	790.800 z	processing
	H	processing
	03.03CH	sync
	03.03CH
	BANK AF COM esc
		sync
	Freq. occupied	B.Ch

790.800 MHz 1.

Adjustment tips for the operating menu

The following adjustment tips apply to the operating menus of all receivers of the EM 3731/3732 receiver family.

Setting the receiving frequency

Via the “Tune” menu, you can:

yset the receiver to a receiving frequency that can be freely selected within the preset frequency range. The receiving frequencies are tunable in 5-kHz increments within the switching bandwidth of 90 MHz max. If you want to use a receiving frequency from the enclosed frequency tables instead, see “Selecting a frequency bank and a channel” on page 28.

ychange and store the receiving frequencies in the 60 channels of the frequency bank “U” (see page 29)

Change to the setting mode of the “Tune” menu.

The first three digits of the receiving frequency start flashing.

Change the first three digits of the receiving frequency by turning the jog dial 7.

Confirm the first three digits of the receiving frequency by pressing the jog dial 7.

The last three digits of the receiving frequency start flashing.

Change the last three digits of the receiving frequency by turning the jog dial 7.

After you have selected the six digits of the receiving frequency, press the save button 8.

The selected receiving frequency is set and automatically stored on the channel “01” of the frequency bank “U”, i.e. the previously stored frequency is overwritten. The display changes to the selection mode of the operating menu.

Selecting a frequency bank and a channel

Via the “B.Ch” menu, you can select a frequency bank and a channel from the enclosed frequency tables.

Change to the setting mode of the “B.Ch” menu. The number of the frequency bank starts flashing.

Select the desired frequency bank by turning the jog dial 7.

Confirm the frequency bank by pressing the jog dial 7. The number of the channel starts flashing.

Select the desired channel by turning the jog dial 7.

Note:

If during the last scan channels were detected that were occupied or subject to interference, these channels are marked with a warning triangle and the text “Freq. occupied” in the “Tune” menu.

After you have selected the frequency bank and the channel, press the save button 8.