Using the receiver
Connecting the headphones/adjusting the volume
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
Set the volume for the connected headphones to the minimum before putting the headphones on.
|
|
|
|
|
|
|
| The EM 3731 single receiver features a headphone output 2. The two |
|
|
|
|
|
|
|
| receivers of the EM 3732 or EM 3732 Command twin receiver have a |
|
|
|
|
|
|
|
| common headphone output 2. This common headphone output 2allows |
|
|
|
|
|
|
|
| you to either monitor the audio signal of one receiver or to simultaneously |
|
|
|
|
|
|
|
| monitor the audio signals of both receivers. |
|
|
|
|
|
|
|
| Set the headphone volume control 3to the lowest volume by turning |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| it to the left as far as possible. | |
|
|
| 300 |
| PEAK | 790.8 | ||
| True Diversity Receiver EM 3732 |
| ||||||
| 100 |
| 100 |
| ||||
|
|
| A RF B | % DEV |
|
| ||
| 10 |
| 50 | 03.03 |
| |||
| 30 |
|
|
| Connect headphones with a ¼” (6.3 mm) stereo jack plug to the | |||
|
|
|
| μV |
| 10 |
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
headphone output 2.
To monitor the audio signals of one of the two receivers of a twin receiver:
100 | 100 | 790.800 z |
| save | |
A RF B | % DEV |
| M |
|
|
300 | PEAK |
| H |
|
|
10 | 50 | 03.03CH | AF | COM | sync |
esc | |||||
30 |
| BANK |
|
| |
μV | 10 |
|
|
|
|
Press the headphone button 0of the receiver whose audio signals you want to monitor.
To simultaneously monitor the audio signals of both receivers of a twin receiver:
Simultaneously press the headphone buttons 0 of both receivers. The audio signals of the left receiver are output via the left headphone channel, the audio signals of the right receiver are output via the right headphone channel.
Increase the volume gradually.
To switch the headphone output off:
Press the headphone button 0 of the receiver whose headphone output you want to switch off.
Deactivating the lock mode
When the receivers are remote controlled via a PC and the supplied “Wireless Systems Manager” software, their buttons can be locked via the “Wireless Systems Manager” software.
To deactivate the lock mode:
| Press the esc button 6 until the progress bar is complete and the |
Hold esc to unlock | status display appears. |
The lock mode is deactivated and the settings can be made manually. |
20