Sennheiser EM 3732, EM 3731, EM 3732 Command manual 33

DEV	M	save digital audi
	790.800 z	processing
	H
	03.03CH	sync
	BANK AF COM	esc

sync

AF Out

+12 dB

+12

DEV	M	save digital audi
	790.800 z	processing
	H
	03.03CH	sync
		esc
	BANK AF COM

sync

Clock

44.1

48 kHz 48 88.2

96

Ext.

DEV	M	save digital audi
	790.800 z	processing
	H
	03.03CH	sync
	BANK AF COM	esc

sync

The operating menu

￿Change the setting to “Booster Feed On” or “Booster Feed Off” by turning the jog dial 7.

￿Press the save button 8.

The selected setting is stored. When the booster supply voltage is switched on, the two LEDs N and S light up. The display changes to the selection mode of the operating menu.

Adjusting the audio output level

Via the “AF Out” menu, you can adjust the maximum output level of the audio outputs (AF out and Command).

With the EM 3732 Command, the audio level of the Command output 1 L corresponds to the level of the audio output 1 Mand the audio level of the Command output 2 Jcorresponds to the level of the audio output 2 K.

The following figures are a guide to the best settings:

y	Line input level:	+5	to	+18 dB
y	Microphone input level:	–10	to	+4 dB

To obtain the best signal-to-noise ration, adjust the respective maximum audio level to the settings shown above.

￿Change to the setting mode of the “AF Out” menu. The current setting starts flashing.

￿Adjust the audio output level by turning the jog dial 7. The display shows the selected audio output level.

￿Press the save button 8.

The selected setting is stored. The display changes to the selection mode of the operating menu.

Selecting the sampling rate for digitalization

Via the “Clock” menu, you can select the sampling rate with which the analog signal is digitalized and output via the digital balanced XLR-3M audio output G. You can choose between the sampling rates “44.1 kHz”, “48 kHz”, “88.2 kHz”, “96 kHz” and “Ext.”. “Ext.” means that the receiver will use one of above sampling rates from the external word clock generator. In this case, you first have to connect an external word clock generator to the BNC socket H (see “Connecting an external word clock generator” on page 18) and switch it on.

￿Change to the setting mode of the “Clock” menu. The current setting starts flashing.

￿Select the desired sampling rate by turning the jog dial 7.

￿Press the save button 8.

The selected sampling rate is stored. The display changes to the selection mode of the operating menu.

Note:

If you select “Ext.” even though no external word clock signal is available at the BNC socket for word clock input H (e.g. because the

31