Sennheiser EM 3732, EM 3731, EM 3732 Command NAME, NAME

The operating menu

Display

Selecting the status display

Via the “Display” menu, you can select the status display:

	Selectable status display	Contents of the display
1.	“Name”
		M
	displays the freely selectable name	790.800 Hz
		NAME
2.	“Bank/Channel”	M
	displays the frequency bank and the	790.800 Hz
	channel number	BANK
		03.03CH
3.	“Name/Command”
		M
	displays the freely selectable name	790.800 Hz
	and the command display	NAME	AF	COM
	(EM 3732 Command receiver only)
4.	“Bank/Channel/Command”	M
	displays the frequency bank, the channel	790.800 Hz
	number and the command display	BANK	AF	COM
	(EM 3732 Command receiver only)	03.03CH

790.800 NAME

1

￿ Change to the setting mode of the “Display” menu.

The current status display starts flashing.

￿ Select one of the four status displays by turning the jog dial 7.

￿ Press the save button 8.

DEV	M	save digital audi
	790.800 z	processing
	H
	03.03CH	sync
	BANK AF COM	esc

sync

The selected status display becomes effective. The display changes to

the selection mode of the operating menu.

IP-Addr

192. 192.

168. 049.

0. 068.

0 Auto

DEV	M	save digital audi
	790.800 z	processing
	H
	03.03CH	sync
		esc
	BANK AF COM

sync

Changing the IP address

Via the “IP-Addr” menu, you can display and change the receiver’s IP address. The IP address consists of four bytes and each byte consists of up to three digits (from 0 to 255). The receiver is factory-preset to dynamic IP addressing (“Auto”).

To manually assign an IP address:

￿Change to the setting mode of the “IP-Addr” menu. The first byte starts flashing.

￿Select a value between 0 and 255 by turning the jog dial 7.

￿Press the jog dial 7 to confirm the first byte and change to the next byte.

￿Repeat the last two steps to select all four bytes.

￿After you have selected the complete IP address, press the save button

8.

￿Switch the receiver off and on again (see “Switching the receiver on/ off” on page 19).

The new IP address becomes effective.

36