Putting the transmitter into operation
Putting the transmitter into operation
Setting up the transmitter on a flat surface
Do not fit the device feet when mounting the transmitter into a 19" rack.
| Clean the base of the transmitter where you want to fix the device feet. |
| Fit the device feet to the four corners of the transmitter. |
| Place the transmitter on a flat, horizontal surface. Please note that the device feet can |
| leave stains on delicate surfaces. |
| Mounting the transmitter into a 19" rack |
|
|
CAUTION! | Risks when rack mounting the transmitter! |
When installing the device in a closed or
Make sure that the ambient temperature within the rack does not exceed the permissible temperature limit specified in the specifications.
If necessary, provide additional ventilation.
Make sure that the mechanical loading of the rack is even.
When connecting to the power supply, observe the information indicated on the type plate. Avoid circuit overloading. If necessary, provide overcurrent protection.
When rack mounting, please note that intrinsically harmless leakage currents of the individual mains units may accumulate, thereby exceeding the allowable limit value. As a remedy, ground the rack via an additional ground connection.
Slide the transmitter into the 19" rack. | |
| Secure the rack mount “ears” to the rack using four screws (not included in the |
| delivery). |
PEAK PEA | |
0 | 0 |
AF I AF | |
Connecting the antennas
You have the following options:
•For professional use, we recommend connecting a remote antenna and, if necessary, using Sennheiser antenna accessories (see next section and the chapter “Connecting several transmitters to a remote antenna” on page 9).
•If the transmitter is to be put into operation without a large amount of installation work, you can:
–connect the supplied rod antenna to the rear of the transmitter (see page 9) or
–use the optional GA 3030 AM antenna front mount kit (see page 9).
8