Adjusting settings via the operating menu
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
Software Revision
Exit
Press the jog dial.
The frequency selection appears.
Set the desired frequency.
Press the jog dial.
Your settings are stored. The “Tune” menu item appears.
Adjusting the receiver parameters and activating/deactivating their transfer to the receiver – “Sync Settings”
Via the “Sync Settings” submenu, you can adjust the following parameters for the EK 2000 IEM receiver.
Menu item | Transferred receiver parameter |
|
|
Balance | Balance or Focus setting (“−15”/“+15”) |
|
|
Squelch | Squelch setting (“5 dB” ... “25 dB”) |
|
|
Mode | Audio mode setting (“Stereo”/“Focus”) |
|
|
High Boost | Treble boost setting for output signal (“flat”/“High boost” (8 dB at 10 kHz)) |
|
|
Auto Lock | Lock mode setting (“Active”/“Inactive”) |
|
|
Limiter | Limiter setting (“−18 dB”, “−12 dB”, “−6 dB”, “Off”) |
|
|
Exit | Exits the “Sync Settings” submenu and returns to the extended menu |
| “Advanced Menu” |
|
|
You can specify for each parameter whether it is to be transferred to the receiver during synchronization.
Parameter | Transfer is ... |
|
|
PEAK | ... deactivated |
400
30
20 |
| ||||
10 |
|
|
| ||
|
| Sync |
| ||
RF |
| AF |
|
| |
| PEAK |
| ... activated | ||
400
30
20 |
| ||
10 |
|
| |
|
| Sync | |
RF |
| AF |
By pressing the
button on the transmitter, the parameters are transferred from the transmitter to the receiver (see page 15).
27