Using the transmitter

￿ Press the jog dial.

The RF signal is deactivated. The transmission icon isnot displayed. In addition, the display backlighting changes from orange to red and “RF Mute” flashes in alternation with the standard display.

To activate the RF signal:

￿Press the STANDBY button.

“RF Mute Off?” appears on the display pane.

￿ Press the jog dial.

The RF signal is activated and the transmission icon is displayed. The display backlighting changes from red to orange.

To deactivate the RF signal on switch-on:

￿See “offline operation” on page 13.

CAUTION!

Stereo Transmitter SR 2000 IEM

PEAK PEAK

00 -10 -10 -20 -20 -30 -30

-40 -40

AF I AF II

Monitoring the audio signal via headphones

Danger of hearing damage!

Listening at high volume levels for long periods can lead to permanent hearing defects.

￿Set the headphone volume control  to the minimum position before putting the headphones on.

￿Do not continuously expose yourself to high volumes.

￿Set the headphone volume control  to the minimum position.

￿Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output .

￿Gradually increase the volume and monitor the audio signal with the lowest possible volume.

Synchronizing transmitters and EK 2000 IEM receivers via the infra-red interface

Synchronization allows you to quickly and easily transfer transmitter and receiver settings from one device to the other, especially if you want to configure a multi-channel system. There are two transfer directions:

1.Easy Setup Sync: Transfer from the receiver to one or several transmitters

Once you have performed a frequency preset scan with a receiver, you can use the Easy Setup Sync function to transfer unused frequency presets from the receiver to the transmitters via the infra-red interface. In order to set up a multi-channel system, you use the diversity receiver to transfer the first unused channel from the selected frequency bank to the first transmitter and the next unused channel to the second transmitter and so on, thus ensuring that all transmitters of a multi-channel system operate on suitable frequencies.

2.Sync: Transfer from a transmitter to a receiver

Once you have selected and set the desired receiver settings on the transmitter (either manually or using the Easy Setup Sync function), you transfer these settings to a receiver. This configures the receiver and establishes a transmission link between transmitter and receiver.

15