Using the transmitter

Easy Setup Sync

Sync

 

 

 

 

 

The first unused frequency preset is

The current frequency bank and channel

transferred from the receiver to the

setting as well as the parameters

transmitter.

adjusted via the “Sync Settings” menu

When the transfer is completed, the

itemaretransferredfromthetransmitter

to the receiver.

 

 

display panel of the transmitter displays

 

 

 

 

 

 

the numbers of the transferred

When

the transfer

is completed,

“ ”

frequency bank and channel.

appears on the display panel of the

Please note that the transmitter does not

transmitter. The

transmitter

then

switches back to the standard display.

automatically store the frequency bank

 

 

 

 

and channel setting.

The

transferred

parameters

are

 

automatically adjusted and stored by the

 

receiver. The transmission link between

 

transmitter and receiver is now

 

established.

 

 

 

 

 

 

 

￿ Place the infra-red interface of the

–

 

 

 

diversity receiver in front of the infra-red

 

 

 

 

interfaces of the remaining transmitters,

 

 

 

 

one after the other.

 

 

 

 

In each case, the next unused frequency

 

 

 

 

preset is transferred from the receiver to

 

 

 

 

the transmitter.

 

 

 

 

 

 

 

 

 

Either:–

￿Store the frequency bank and channel setting by pressing the jog dial on your transmitters.

The RF signal is activated. You can carry out the Sync function (see right-hand column) at a later time to establish a transmission link between transmitters and receivers.

Or:

–

￿ Immediately synchronize your receivers

with your transmitters by carrying out

the Sync function (see right-hand

column).

 

The

icon in the left lower corner of

the transmitter display indicates that the

Sync function can be carried out. The

transmission link between transmitters

and receivers is established.

 

 

–

To cancel the transfer:

 

￿ Press the STANDBY button on the

 

transmitter.

 

“ ” appears on the display panel of the

 

transmitter. “ ” also appears if no

 

suitable receiver was found.

 

 

17