Putting the transmitter into operation
Connect the rod antennas & to the two BNC sockets '.
& ' 
| | | | Connecting an audio source to the input sockets |
PUSH | PUSH | | Stereo Trans | Use a suitable cable to connect the output of the audio source (e.g. mixing console) to the |
| FREQ RANGE-Dw | IC 2099A-SR20x0 |
| 790-865 mHz | |
| ART NO 503841 | | DESIGNED AND MADE IN GERM | ¼” (6.3 mm) jack/XLR-3 combo socket BAL AF IN L (I) and/or BAL AF IN R (II) . |
| SER NO 2518100095 | |
| ANT | | |
| | | |
| BAL | | | Adjust the output level of your audio source. |
L(I) | AF IN | | |
+ 22dBu MAX R(II) | RF OUT |
| | | |
| | | | |
Via the operating menu, adjust the transmitter’s input sensitivity. The input sensitivity is adjusted via the “Sensitivity” menu item and is common for both inputs (see page 22).
You can connect several transmitters to the same audio source (see next chapter).
Daisy chaining audio signals
You can transmit the same audio signal (e.g. the sum of all audio channels of a mixing console) to several receivers of a multi-channel system. To do so, you have to daisy chain this audio signal from one transmitter to the next via the output sockets LOOP OUT BAL L (I) or LOOP OUT BAL R (II) . The audio signal is then transmitted by all transmitters on one of the two channels L (I) or R (II). The second channel allows you to transmit an individual audio signal (e.g. the instrument of a musician). Using the balance setting on the receiver, you can then adjust the relative levels of the sum ofallaudio channels and the individual audio signal. For this, the transmitter has to be set to stereo mode and the receiver to Focus mode.
To daisy chain an audio signal from one transmitter to the next:
Route a signal from the audio source to the input socket (in this example: BAL AF IN R(II) ) of transmitter A.
