Synchronizing the transmitter with the EK 2000 IEM receiver
SynchronizingthetransmitterwiththeEK 2000 IEM receiver
When synchronizing your transmitter with the EK 2000 IEM receiver, please observe the following:
Only use a transmitter and a receiver from the same frequency range (see the type plates on the transmitter and the receiver).
Make sure that the desired frequencies are listed in the enclosed frequency information sheet. You can also contact your Sennheiser partner who will be pleased to calculate
Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.
The frequencyinformation sheet can alsobe downloaded from the corresponding product page on our website at www.sennheiser.com.
Synchronizing the transmitter with an EK 2000 IEM receiver – individual operation
Upon delivery, transmitter and receiver are synchronized with each other. If, however, you cannot establish a transmission link between transmitter and receiver, you have to synchronize the channels of the devices:
First carry out the Easy Setup Sync function (see table on page 16,
Then carry out the Sync function (see table on page 16,
Alternatively, you can set the channel on the transmitter manually:
Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver.
Synchronizing transmitters with EK 2000 IEM receivers – multi- channel operation
Network operation In
Advantages of controlling the transmitters via the “Wireless Systems Manager” (WSM) software:
•Detailed overview of all transmission and receiving channels
•Remote control of all transmitters in the network
•Combination of transmitters of different frequency ranges (see page 4).
Connect your transmitters and your PC in a network (see page 12).
Switch your transmitters and your PC on.
Launch the “Wireless Systems Manager” (WSM) software.
To set up your
30