Synchronizing the transmitter with the EK 2000 IEM receiver
Operation without First carry out the Easy Setup Sync function (see table on page 16,
Then carry out the Sync function once for each transmitter/receiver pair (see table on page 16,
This establishes a transmission link between the transmitter and the receiver.
Using freely selectable transmission frequencies
You can also freely select the frequencies and store these frequencies in the frequency banks “U1” to “U6”.
If you want to use the frequency banks “U1” to “U6”:
Make sure to use transmitters and receivers from the same frequency range (see page 4 and the type plates of the devices).
To ensure that the desired frequencies are
Contact your Sennheiser partner (see www.sennheiser.com).
Set each transmitter to the same frequency bank.
On one of the transmitters, select a channel within this frequency bank (see page 25).
Assign this channel one of the calculated transmission frequencies (see page 25).
Synchronize a receiver with your transmitter (
, see page 16).
OR
Manually set the receiver to thesamefrequency bank, channel and frequency that you set on the transmitter.
Repeat for the remaining transmitters and receivers as described above.
31