Sharp 240T, 210T manual Plug and Play, Installing the Video Driver, Self-Test Feature Check Stfc

body2.fm Page 6 Monday, September 18, 2000 8:53 AM

Setting up Your LCD Monitor

If you are experiencing the above, then please follow the steps given below to solve the problem.

1.Touch the “MENU” button to bring up OSD window.

2.Select “Hz” menu.

3.Press “MENU” button seven times while keeping “Hz” menu highlighted.

4.The monitor’s displayed mode will be changed from UXGA mode to WUXGA mode, or from WUXGA mode to UXGA mode depending on the current mode.

Plug and Play

The adoption of the new VESA® Plug and Play solution eliminates complicated and time consuming setup. It allows you to install your monitor in a Plug and Play compatible system without the usual hassles and confusion. Your PC system can easily identify and configure itself for use with your display. This monitor automatically tells the PC system its Extended Display Identification Data (EDID) using Display Data Channel (DDC) protocols so the PC system can automatically configure itself to use the flat panel display. If your PC system needs a video driver, follow the instructions given below according to the operating system your computer uses.

Installing the Video Driver

The CD that accompanies this product contains the necessary drivers for installing your monitor. Please refer to the driver installation instructions included with your CD package for more information.

Self-Test Feature Check (STFC)

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. Make sure that PC is selected as a primary source by checking if the source indicator LED labeled “PC” is on. If your monitor and computer are properly connected but the monitor screen remains dark and the power indicator is blinking, run the monitor self-test by following the steps given below:

Power Indicator

Figure 4. Power Indicator

English 6