Sharp AR-157E, AR-153E operation manual Caution label on the unit, Cautions on using

Models: AR-157E AR-153E

1 121
Download 121 pages 9.52 Kb
Page 3
Image 3
CAUTIONS

CAUTIONS

Caution label on the unit

The label (Caution label on the unitCautions on using) in the fusing area of the unit indicates the following:

Important points when selecting an installation site: Caution, risk of danger Manual background: Caution, hot surface

Cautions on using

Follow the cautions below when using this unit.

Manual backgroundWarning:

The fusing area is hot. Exercise care in this area when removing misfed paper.

Do not look directly at the light source. Doing so may damage your eyes.

Do not switch the unit rapidly on and off. After turning the unit off, wait 10 to 15 seconds before turning it back on.

Unit power must be turned off before installing any supplies.

Manual background Caution:

Place the unit on a firm, level surface.

Do not install the unit in a humid or dusty location.

When the unit is not used for a long time, for example for consecutive holidays, turn the power switch off and remove the power cord from the outlet.

When moving the unit, be sure to turn the power switch off and remove the power cord from the outlet.

Do not cover the unit with a dust cover, cloth or plastic film while the power is on. Doing so may prevent heat radiation, damaging the unit.

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

The socket-outlet shall be installed near the unit and shall be easily accessible.

Important points when selecting an installation site

Do not install your unit in areas that are:

damp, humid, or very dusty

exposed to direct sunlight

poorly ventilated

subject to extreme temperature or humidity changes, e.g., near an air conditioner or heater.

Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. Also make certain the outlet is properly grounded.

Connect the unit to a power outlet which is not used for other electric appliances. If a lighting fixture is connected to the same outlet, the light may flicker.

Be sure to allow the required space around the machine for servicing and proper ventilation.

 

8"

4"

4"

1

Page 3
Image 3
Sharp AR-157E Caution label on the unit, Cautions on using, Important points when selecting an installation site