Sharp AR-163, AR-162 To continue with other user programs, press the key, User Programs

USER PROGRAMS

4	Select the desired parameter using the numeric keys.
	● The entered parameter number will blink on the right side of the copy

quantity display.

● The parameters are shown in the table below.

For example, to change the setting of the auto power shut-off timer to 60 min., press key 2.

Program name	Parameters
Auto clear time	0	OFF	1	30 sec.	* 2	60 sec.	3	90 sec.	4	120 sec.
	5	10 sec.
Preheat mode**	0	OFF ** 1		30 sec.	2	60 sec.	* 3	90 sec.	4	120 sec.
Auto power shut-off timer	* 1	30 min.	2	60 min.	3	90 min.	4	120 min.	5	240 min.
Stream feeding mode	* 0	OFF	1	ON
Auto power shut-off setting	0	OFF	* 1	ON
Border line for 2 in 1 or 4 in 1	* 0	OFF	1	ON
Rotation copy	0	OFF	* 1	ON
Auto paper select mode	0	OFF	* 1	ON
Auto tray switching	0	OFF	* 1	ON
Erase width adjustment	0	0 mm	1	5 mm	* 2	10 mm	3	15 mm	4	20 mm
	(0	0"	1	1/4"	* 2	1/2"	3	3/4"	4	1")
Layout in 2 in 1 copy	* 1	Pattern 1	2	Pattern 2
Layout in 4 in 1 copy	* 1	Pattern 1	2	Pattern 2	3	Pattern 3	4	Pattern 4
Offset of paper output tray	0	Upper OFF, lower OFF			* 1	Upper ON, lower ON
	2	Upper ON, lower OFF			3	Upper OFF, lower ON

●Factory default settings are indicated with an asterisk (*). For layout in 2 in 1 copy and 4 in 1 copy, see page 61.

**In European countries, the default setting of the preheat mode is 1 ( 30 sec.). For other programs, factory default settings in these countries are same to those shown above with an asterisk (*).

If you select “0” (OFF) in a program, the corresponding function will be disabled.

5	Press the START ( ) key.
	● The right-hand number in the copy quantity display will be steadily lit

and the entered value will be stored.

GENERAL INFORMATION User programs

To continue with other user programs, press the key

6 and then repeat steps 2 to 5. To exit the user program mode, press the light () key.

●All the alarm indicators will go out.

37