Sharp AR-162 Toner Cartridge Replacement, Genuine Supplies, slide the cover out until it stops

TONER CARTRIDGE REPLACEMENT

When the toner cartridge replacement required ( ) indicator lights up, replacement of the toner cartridge will be needed soon. Obtain a new cartridge.

When the toner cartridge replacement required ( ) indicator blinks, the toner cartridge must be replaced before copying can be resumed. Replace the toner cartridge by following the procedure below.

During a long copy run of a dark original, the indicator may blink and the copier stop, even though toner is left.The copier will feed toner up to 2 minutes and then the START key () indicator will light up. Press the START () key to restart copying.

For best copying results, be sure to use only SHARP products.

The package of SHARP toner has the Genuine Supplies label.

GENUINE SUPPLIES

Toner cartridge replacement

INDICATORS

STATUS

Open the bypass tray. Lift slightly on the side cover and

1 slide the cover out until it stops.

Push gently on both sides of the front cover to open the

2 cover.

Toner cartridge lock	Push the toner cartridge lock release lever and pull the
	3 toner cartridge out. Remove the toner cartridge while
release lever
	supporting it with the left hand at the green label position.
	● For disposal of the old toner cartridge, contact your dealer.

Remove the new toner cartridge from the bag. Hold the

4 or 5 times	4 cartridge on both sides and shake it horizontally four or
	five times.

28