Using the Organizer for the First Time

Be sure to perform the following operations before using the Organizer for the first time.

1.Press the RESET switch while holding ON . Release the RESET switch and then release ON .

“CLEAR ALL DATA OK (Y/N) ?” is displayed.

Under certain conditions the message may appear as “Data has been impaired ! Press [Y] to CLEAR ALL memory”. Proceed to the next step in either case.

2.Press Y .

3.The Organizer is now initialized. Proceed to set the date and time of the clock. (Refer to page 7.)

Press the RESET switch with a ball-point pen or similar object. Do not use an object with a breakable or sharp tip.

When Abnormal Conditions Cause a Malfunction

If the Organizer is subjected to strong, extraneous electrical noises or shocks during use, an abnormal condition may occur in which no keys (including ON ) will respond. If this happens, press the RESET switch.

Noises or shocks may erase some or all of the Organizer’s memory.

Auto Power Off Function

When none of the keys have been pressed for approximately 7 minutes, the Organizer automatically turns the power off to save the batteries. (The actual time may vary depending upon the condition of use.) Press ON to resume operation.

Backlight

The Organizer provides a built-in Backlight, which allows you to view the display and use the Organizer even in low-light

conditions. Pressing once illuminates the display for as long as you continue to use the Organizer, until you have not typed any key for the interval you set. (See the following section, “Setting up the Backlight”.)

1

Page 3
Image 3
Sharp El-6890S, El-6850, El- 6890 operation manual Using the Organizer for the First Time, Press Y