Sharp FO-B1600 operation manual Messages and Signals, Press Start KEY

Messages and Signals

Messages and Signals

Display messages

Note: If you have turned on the Caller ID function, see page 73 for display messages related to Caller ID.

ADD PAPER & /	Check the printing paper. If the tray is empty, add
PRESS START KEY	paper and then press the START/MEMORY key. If
(alternating messages)	there is paper in the tray, make sure it is inserted
	correctly (take out the stack, align the edges evenly,
	and then reinsert it in the tray) and then press the
	START/MEMORY key.
CHANGE CARTRIDGE	This message appears after you install or replace the
	print cartridge (see page 19).
CHECK CARTRIDGE	The print cartridge is missing and must be installed,
	or is not installed correctly.
COVER OPEN	The print compartment cover is open. Close it.
DOCUMENT JAMMED	The original document is jammed. See the following
	section, Clearing Paper Jams. Document jams will
	occur if you load more than 20 pages at once or load
	documents that are too thick (see page 33). The
	document may also jam if the receiving machine
	doesn’t respond properly when you attempt to send a
	fax.
FAX RX IN MEMORY	A fax has been received in memory because the print
	cartridge needs replacement, you have run out of
	printing paper, or the paper is jammed. The fax will
	print out automatically when the problem is fixed.
FUNCTION MODE	The FUNCTION key has been pressed.
INK NEAR EMPTY	The cartridge is nearly empty (approximately one
	eighth of the ink remains).
LINE ERROR	Transmission or reception was not successful. Press
	the STOP key to clear the message and then try
	again. If the error persists, see Line error on page 98.

9. Trouble- shooting

103