Sharp FODC525, FODC600 Setting 22: DIAL MODE, Setting 24: MULTI TTI, Setting 20: ANTI-JUNKFAX, Setting 21: ALARM VOLUME, Setting 23: QUICK ON-LINE

Optional Settings

Setting 20: ANTI-JUNK FAX

Select ON to block reception from fax numbers entered in the Anti Junk Fax

List. Select OFF to allow reception from all numbers. Press or to

START/

make the selection and then press ENTER .

♦Initial setting: OFF

Setting 21: ALARM VOLUME

This sets the volume of the beep sound that alerts you to error conditions and

informs you that operations have been completed. Press or to

START/

select a volume level (HIGH, LOW or OFF) and then press ENTER ..

♦Initial setting: LOW

Setting 22: DIAL MODE

This sets the dial mode. Select TONE if you are on a touch-tone line, or

PULSE if you are on a pulse dial (rotary) line. Press or to make

START/

the selection and then press ENTER .

♦Initial setting: TONE

Setting 23: QUICK ON-LINE

When you transmit a multi-page document, this setting determines whether the machine will dial the receiving party and begin transmitting while scanning is still in progress, or wait until all pages have been scanned before dialing. Select ON to have the machine dial and begin transmission while scanning is still in progress, or OFF to have the machine wait until all pages have been

scanned. Press	or	to make the selection and then press	START/
			ENTER .

♦Initial setting: ON

Setting 24: MULTI TTI

If you are using Department Control, you can select ON to have the department name (the name associated with the department code entered by an operator to access the fax) appear at the top of each transmitted document. This will appear in place of the name entered in Entering Your Name and Fax Number in Chapter 1. Select OFF to turn Multi TTI off (the

7. Optional Settings

207