Sharp FODC525, FODC600 Press, Press, Press, and then, selected, to select, Press ENTER, Press ENTER, FAX TRANSFER SETTING, . Make sure that SET is

						Inbound Routing
2
	Press	START/	and then	to select	ENTRY MODE
		ENTER				07:SYSTEM # MODE
	FAX TRANSFER SETTING.					08:STORE JUNK FAX #
						09:DEPT. PASSCODE
						10:BOOK ENTRY MODE
						11:FAX TRANSFER SETTING
3	Press	START/	. Make sure that SET is		3:ENFAX TRANSFERYMODE SETTING
		ENTER				1=SET
					ENTER #(01-10, , )
	selected.					2=CLEAR
						3=ON/OFF
4	Press	START/				FAX TRANSFER SET
						SETTING #=
		ENTER .

5 Enter a 2-digit number from 01 to 41. This number is used to identify the set that you are storing.

6 Enter a name for the set by pressing the letter entry keys (see Step 6 on page 26). (Maximum of 20 characters.)

If you don’t want to enter a name, go directly to Step 7.

3. Network Scanner

7 START/

Press ENTER .

•If “TRANSFER ALL” has already been selected for a set, or if you are storing the set from a personal book, you must enter one or more sender’s numbers (the display at right does not appear). Go to step 10.

FAX3:ENTRANSFERYMODE SET # 01 ENTER1=INPUT#(01TSI#-10, , )

2=TRANSFER ALL

The set number appears here

8 Press or to select INPUT TSI# if you wish to only forward faxes from specific sender’s numbers.

Select TRANSFER ALL if you wish to forward all received faxes.

9 START/

Press ENTER .

•If you selected TRANSFER ALL in Step 8, go to step 12.

105