Instructions for attaching a VESA compliant arm
An arm or stand based on the VESA standard (commercially available) can be attached to the monitor.
Procurement of the arm or stand is at the customer's discretion.
When choosing the arm to be installed please take note of the following points.
-The arm should be compatible with the VESA standard, and there must be a gap of 75 mm x 75 mm between the screw holes on the section to be attached.
-The arm must not fall off or break off after being attached to the monitor.
1.Ensure that both the monitor and computer are switched off.
2.Unplug the power cord from the AC outlet.
3.Remove the analog signal cable and the audio cable from the computer.
4.Press down on the stand and gently fold back the monitor.
-Be careful not to allow your fingers to be pinched.
-Do not overly bend the cable or add extension cords as this could lead to malfunction.
5.Being careful not to damage the monitor, spread out a soft cloth and lay the monitor on it display- side down.
6. Attach the arm to the monitor with four screws.
Note:
-The screws used to attach the arm should be M4 screws with a length of 8 mm ~ 10 mm protruding from the surface to be attached. Using different screws could cause the monitor to fall off or to be internally damaged.
Screw used to attach arm
Arm
Part of monitor to which arm is attached
7.Connect the analog signal cable, the audio cable and the power cord.
24
