Sharp MD-MT20H Recording Using The Analogue Cable, Recording from CDs or MDsSynchro recording

RECORDING USING THE ANALOGUE CABLE

■Recording from CDs or MDs (Synchro recording)

Synchro recording is a method that detects the playback sound from the source equip- ment. When sound is present, it automati- cally starts the recording. When the source is silent, the recording will be paused.

1 Connect the external equipment. (See page 9.)

2 Insert a recordable MiniDisc.

2

1

OPEN

4

3

3 Press the REC button.

●To record from a tuner, first tune in a broadcast.

●To record from a CD, first start play- ing the track you want to record.

4 Whilst playing sound from the external equipment connected to this unit, press the 5 or 4 button to adjust the re- cording level.

0dB

–4dB

●Adjust the recording level so that the maximum sound volume from the source makes the reading swing somewhere between -4 dB and 0 dB.

●To record from a CD, first adjust the recording level. Then put the equip- ment connected to this unit into the playback stand-by mode.

5 Press the ENTER/SYNC button.

Flashing

6 Begin playback on the source equip- ment.

●Recording will begin automatically.

To interrupt recording:

●When the source equipment is stopped, the unit will enter the synchro recording stand-by mode. When playback is re- sumed, a recording will be resumed.

●If a silence lasts for 3 seconds or more, the recording will be paused.

●Pressing the 06 button on this unit (when in this mode) will cause the unit to enter the recording stand-by mode and cancel the synchro recording mode.

●The track number will be increased by one each time the recording is inter- rupted.

To stop recording:

Press the ■/:OFF button.

●If the unit is left unattended after the recording is complete, the power will automatically shut off in approximately 2 minutes.

11

* MD-MT20H FOR UK(01-21) 12 99.3.11, 2:29 PM