To turn off the power:
Press the ■/:OFF button whilst in the stop mode.
●After the track number has been written on the disc, the power will shut off auto- matically. (For details about the TOC, see page 21.)
To remove the MiniDisc:
Turn off the power and move the OPEN lever in the direction indicated by the arrow.
2
1
OPEN
■Recording from a tuner or a CD (Manual recording)
●Manual recordings can be started and stopped as you like.
1 Place the unit in the recording
2 Press the 06 button.
●Recording will start.
●To record from a CD, press the 06 button, and then start playback on the equipment connected to this unit.
●Track numbers can be created whilst recording. (Page 18)
To interrupt recording:
Press the 06 button whilst recording.
●The unit will enter the recording stand- by mode.
●To resume recording, press the 06 but- ton again.
The track number will be increased by one each time you interrupt a record- ing.
12
Recordings can not be made in the following situations:
●Recording on a
●If a MiniDisc is protected against ac- cidental erasure. (page 10)
About the recording level:
●If the recording level is too low, the playback sound volume may be too low to hear well. If it is too high, the playback sound may be greatly dis- torted. Since digitally recorded CDs have a large dynamic range (the vol- ume can vary tremendously from very soft to extremely loud), do not set the recording level any higher than is necessary.
Precautions when recording:
●Do not jar or bump the main unit whilst recording. Otherwise, the recording may be unusable.
●Depending on the strength and type of playback signal in the original re- cording, the new recording may not begin or pause at the correct point when in the synchro mode. If this hap- pens, try making a manual recording.
Precautions when inserting a MiniDisc:
●To insert a MiniDisc, push on the middle of the edge of the disc whilst holding it parallel to the main unit.
●If any resistance is felt, do not try to force the MiniDisc into the unit. It may additional more problems. If resis- tance is felt, remove the MiniDisc and try reloading it.
* | 13 | 99.3.11, 2:29 PM |