To stop recording, After recording | Sharp MD-R2, MD-MS702 specification

To stop recording:

Press the ■/:OFF button.

●If the unit is left alone after the record- ing has stopped, the power will be turned off about 2 minutes later.

Press the ■/:OFF button while in the stop mode.

●After the track number has been written on the disc, the power will be turned off

automatically. (For details about the TOC, see page 20.)

Turn off the power and move the EJECT lever in the direction indicated by the arrow.

●Manual recordings can be started and stopped as you like.

1 Put the unit in the recording stand-by	To interrupt recording:
mode. (Perform steps 1 - 4 in the	Press the 06 button while recording.
“Synchro recording” section.)	● The unit will enter the recording stand-
2 Press the 06 button.	by mode.
2 Press the 06 button.	● To resume recording, press the 06
● Recording will start.	button again.
● To record from a CD, press the 06	The track number will be increased by
button, and then start playback on the	one each time you interrupt a record-
equipment connected to this unit.	ing.

●Track numbers can be created while recording. (Page 17)

	Recordings can not be made in the	of playback signal in the original
	following situations:	recording, the new recording may
	● Recording on a playback-only Mini-	not begin or pause at the correct
	Disc (commercially available music)	point when in the synchro mode. If
	● If a Minidisc is protected against ac-	this happens, try making a manual
	cidental erasure (page 9)	recording.
	About the recording level:	Precautions when inserting a Mini-
	● If the recording level is too low, the	Disc:
	playback sound volume may be too	● To insert a Minidisc, push on the
	low to hear well. If it is too high, the	middle of the edge of the disc while
	playback sound may be greatly dis-	holding it parallel to the main unit.
	torted. Since digitally recorded CDs	● If any resistance is felt, do not try to
	have a large dynamic range (the	force the MiniDisc into the unit. It
	volume can vary tremendously from	may cause more problems. If resis-
	very soft to extremely loud), do not	tance is felt, remove the MiniDisc
	set the recording level any higher	and try reloading it.
	than is necessary.	Notes:
	Precautions when recording:	Notes:
	Precautions when recording:	● Whenever any button is pressed, the
	● Do not jar or bump the main unit	remote control display will light for
	while recording. Otherwise, the	about 4 seconds.
	recording may be unusable.	● The REC button does not light.
	● Depending on the strength and type

MD-MS702