Sharp MD-R2, MD-MS702 operation manual Recording Using A Microphone, Mic Sync H, Mic Sync L

RECORDING USING A MICROPHONE

■Recording from the microphone (Mic synchro recording)

The recording will begin automatically in response to a noise or a person speaking. When the sound stops, the recording will pause. This function is convenient when recording lectures, conferences, etc.

Stereo microphone	VOL /
	NAME
(commercially available)
	To the MIC IN jack

1 Connect the stereo microphone to the		5 Press the ENTER/F.PLAY/SYNCHRO
MIC IN jack on the main unit.
		button to select the synchro recording
● When a microphone is connected to
		level. (This level can be changed, even
this unit, the unit will automatically
		while recording.)
switch to input from the microphone.
		● Refer to the following table.
2 Insert a recordable Minidisc.
					Synchro recording		Sound level at which
3 Press the REC button.
					level display				to start recording
● A monaural, long-play recording			input		MIC SYNC H
mode is available. (Page 17)							-24dB
● Timed identification marks can be			Mic
					MIC SYNC L
created while recording. (Page 15)								-12dB
4 Press the 5 or 4button to adjust
		● When the microphone input is set to
the recording level.
				MIC SYNC H, recording will start
	0dB			when		a sound is detected at the
				lowest		volume.	If the unit starts
	-4dB
				recording too often due to low, un-
				wanted noises, set the microphone
				input to MIC SYNC L.

●Adjust the recording level so that the maximum sound volume from the source makes the reading swing be- tween -4 dB and 0 dB.

●When the recording level display is changed from “MIC H” to “MIC L”, the sound will be interrupted momen- tarily. This is normal.

13

MD-MS702