Sharp PG-C20XU Using the Adjustment Feet, Reversed Image Setup, Ceiling-mount Setup

Setting up the Screen

Using the Adjustment Feet

You can adjust the height of the image by raising the projector with the foot releases.

1 Press the foot releases and lift the projector to the desired angle. (Adjustable up to approximately 7° from the standard position.)

2 Remove your hands from the foot releases. Once the adjustment feet have locked in position, release the projector.

3 If the screen is at an angle, the adjusters can be used to adjust the angle of the image.

Returning the projector to its original position

While holding the projector, press the foot releases and slowly lower the projector to its original position.

• When an adjustment is made, the image may become distorted (keystoned), depending on the relative positions of the projector and the screen.

Operation

CAUTION

•Do not press the foot releases when the adjustment feet are extended without firmly holding the projector.

•Do not hold the lens when lifting or lowering the projector.

•When lowering the projector, be careful not to get your fingers caught in the area between the adjustment feet and the projector.

Reversed Image Setup

Rear projection

•Place a translucent screen between the projector and the audience.

•Use the projector’s menu system to reverse the projected image. (See page 36 for use of this function.)

Projection using a mirror

•When the distance between the projector and screen is not sufficient for normal rear projection, you can use a mirror to reflect the image onto the screen.

•Place a mirror (normal flat type) in front of the lens.

•Project the normal image onto the mirror.

•The image reflected from the mirror is projected onto the translucent screen.

•Optimal image quality can be achieved when the projector is positioned perpendicular to the screen with all feet flat and level.

CAUTION

•When using a mirror, be sure to carefully position both the projector and the mirror so the light does not shine into the eyes of the audience.

Ceiling-mount Setup

•It is recommended that you use the optional Sharp ceiling-mount bracket for this installation.

•Before mounting the projector, contact your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center to obtain the recommended ceiling-mount bracket (sold separately). (AN-

PGCM80 ceiling-mount bracket, AN-EP101AP extension tube for

AN-PGCM80.)

•When the projector is in the inverted position, use the upper edge of the screen as the base line.

•Use the projector’s menu system to select the appropriate projection mode. (See page 36 for use of this function.)

E-19