Sharp PGB10S operation manual Switching the Input Mode, Adjusting the Volume

Switching the INPUT Mode

Select the appropriate input mode for the con- nected equipment.

Press , or on the remote control to select the INPUT mode.

•When pressing on the projector, input mode switches in order of

INPUT 1INPUT 2 INPUT 3 .

Note

•When no signal is received, “NO SIGNAL” will be displayed. When a signal that the projector is not preset to receive is received, “NOT REG.” will be displayed.

•The INPUT mode is not displayed when “OSD Display” of the “Options” menu is set to “OFF”. (See page 41.)

About the INPUT mode

INPUT 1 Used for projecting images from

(RGB/ equipment that sends RGB sig- Component) nals or component signals con- nected to the RGB input terminal.

INPUT 2	Used for projecting images
(S-Video)	from equipment connected to
	the S-VIDEO input terminal.
INPUT 3	Used for projecting images
(Video)	from equipment connected to
	the VIDEO input terminal.

INPUT buttons

"On-screen Display of INPUT Mode (Example)

	➝
INPUT 1 mode
Using RGB

Using

Component

INPUT 2 mode	➝
Using S-Video
INPUT 3 mode	➝
Using Video

Projection

Adjusting the Volume

Press or on the remote con- trol to adjust the volume.

Note

• Pressing	will lower the volume.	Volume buttons
Pressing	will raise the volume.

•On the projector, the volume can be ad- justed by pressing or .

-19