PC Operation (Continued)
Advanced operation
This section explains commands for daisy chain connection. The basic communication procedure is the same as in the “Basic operation” section.
<ID numbers>
You can assign a unique ID number to each monitor (see page 31). This allows you to control a particular monitor in a daisy chain of monitors.
Up to about 20 monitors can be connected, depending on the length of
You can assign ID numbers either from the menu screen (using the remote control) or from the PC using
[Example]
PC | ID number: 1 | ID number: 2 | ID number: 3 | ID number: 4 |
If monitors are connected as shown above, you can execute commands like “Set the volume of the monitor with ID 4 to 20”.
When controlling monitors linked in a daisy chain by designating ID numbers, you should basically avoid any duplication of ID numbers.
If the same ID number is assigned to multiple monitors, only the monitor closest to the PC can be controlled with that ID number.
If monitors are connected as shown below, only the monitor (1) can be accessed with ID number 2. Monitor (2) cannot be controlled using that ID number.
[Example]
PC | ID number: 1 | ID number: 2 | ID number: 2 | ID number: 3 |
(1)(2)
ID numbers do not have to be assigned in ascending order starting from the PC. They can also be connected as shown below.
[Example]
PC | ID number: 3 | ID number: 2 | ID number: 4 | ID number: 1 |
E40