Sharp VL-WD255U Attaching and Removing the Battery Pack, Attaching the Battery Pack

Attaching and Removing the Battery Pack

Attaching the Battery Pack

1 Make sure that the Power switch is set to OFF.

Power switch

2 Lift up the viewfinder.

Power source mounting surface

4 Lower the viewfinder.

Preparation

Removing the Battery Pack

1 Perform steps 1 and 2 above.

2 Press the power source PUSH release button (1), and slide the battery pack up and take it out (2).

Power source PUSH release button

3 Align the - mark on the side of the battery pack with the qmark on the camcorder (1), and slide the battery pack down completely until it locks into place (2).

Cautions:

•BEFORE REMOVING THE BATTERY PACK, ALWAYS STOP RECORDING OR PLAYBACK AND TURN THE POWER OFF. Removing the battery pack while shooting or during playback may damage the tape by causing it to wrap around the video head drum or may destroy the SmartMedia card, rendering it unreadable and unwritable.

•Remove the battery pack from the camcorder if you will not use the camcorder for a long period of time.

•Use only SHARP model BT-L221 or BT-L441 battery packs with this camcorder. Use of other batteries may present a risk of fire or explosion.

10