Sharp VL-WD255U Windbreak, Setting the Confirmation Sounds, Type of Confirmation Sound Settings

Windbreak

The windbreak function allows you to reduce annoying noise from strong winds when recording.

1	Set the camcorder to TAPE-CAMERA
	mode.
2	Press the MENU/DISPLAY button until
	the menu screen appears.
3	Select U, then press r on the Opera-
	tion button. Select “WIND” (1), then
	press r (2).
		AUD I O		SE T
			AUD I O MODE
			Z OOM M I C
			W I ND		O F F
					ON

4 Press d or y to select “ON”, then press e.

W I ND ON

5 Press the MENU/DISPLAY button to turn off the menu screen.

To cancel Windbreak

Select “OFF” in step 4 above.

Note:

•Keep the windbreak function off during normal recording. If it is left on, the recorded audio may sound somewhat muffled when played back.

Setting the Confirmation Sounds

A confirmation sound is made when you turn on or off the Power switch, press the REC START/STOP button, or perform other desig- nated operations. Use the procedure below to change the type of sound or to turn off the confirmation sounds altogether.

Type of Confirmation Sound Settings

CHIME: A chiming sound is made.

BEEP: An electronic beeping sound is made.

OFF: No confirmation sound is made.

1 Press the MENU/DISPLAY button until the menu screen appears.

2 Select I, then press r on the Operation button. Select “SOUND” (1), then press r (2).

O T H E RS
	REMO T E
	SOUND	CH I ME
	T I ME COD E	B E E P
	T C OUT	O F F
	D EMO MOD E
	L ANGUAG E

3 Press d or y to select the desired sound setting, then press e.

SOUND B E E P

4 Press the MENU/DISPLAY button to turn off the menu screen.

Note:

•If “OFF” is selected, the sound effect of a camera shutter closing in PHOTO SHOT mode and CARD-CAMERA mode will also be turned off.

Advanced Features

56