Writing and reading all the programming data
You can write all the programming data in the cash register onto an SD memory card (Writing). The existing programming data in the card will all be replaced with the newly written data at this time.
You can also replace the programming data stored in the cash register with those stored in an SD memory card by loading the latter into the cash register(Reading).
Set the mode switch to the PGM position.
Writing
The comfirmation message is printed.
To execute | * |
|
s 141 @ s
Reading
1A
To cancel l
The comfirmation message is printed.
To execute | * |
|
s 147 @ s
1A
To cancel l
*The message “ACCESSING CARD” will appear and stay on the display until all data is completely written or read. When writing or reading is finalized, the message “SD FINAL” will be printed. In case an error occurs, a corresponding error message will be printed.
7Writing of Sales Data
Write all of the existing sales data (daily and periodic totals) onto an SD memory card. You can write the data onto the same card a maximum of 400 times unless the card becomes full.
Set the mode switch to the X1/Z1 position.
The comfirmation message is printed.
To execute | * |
|
650 P @ s
1A
To cancel l
*The message “ACCESSING CARD” will appear and stay on the display until all data is completely written. When writing is finalized, the message “SD FINAL” will be printed. In case an error occurs, a corresponding error message will be printed.
73
