Sharp XV-Z17000 5Setting the Video System 7Adjusting the Dynamic Range, 8Signal Info

Computer Image Adjustment (“SIG-ADJ” Menu) (Continued)

Menu operation ⇒ Page 35

5Setting the Video System 7Adjusting the Dynamic Range

The video input system mode is factory preset to “Auto”; however, a clear picture from the connected audio-visual equipment may not be received, depending on the video signal difference. In that case, switch the video signal.

Selectable items

Auto

PAL

SECAM

*NTSC4.43

NTSC3.58

PAL-M

PAL-N

PAL-60

*When reproducing NTSC signals in PAL video equip- ment.

An optimum picture may not be displayed if an HDMI- capable device’s output signal type and the projector’s input signal type do not match. If this should occur, switch “Dynamic Range”.

Selectable items	Description
Auto	In most circumstances, “Auto” should
	be selected.
Standard	When the black levels of the image
	show banding or appear faded, select
Enhanced
	the item that results in the best picture
	quality.

8Signal Info

Input signal information is displayed.

Note

•The video signal can only be set in VIDEO or S-VIDEO mode.

•When “Video System” is set to “Auto”, you may not receive a clear picture due to signal differences. Should this occur, switch to the video system of the source signal.

6Setting the Video Setup

Selectable items	Description
0 IRE	Sets the black level to 0 IRE.
7.5 IRE	Sets the black level to 7.5 IRE.

Note

•This function is available for the following signals.

With COMPONENT or COMPUTER/

COMPONENT input: - 480I

With S-VIDEO or VIDEO input: - NTSC3.58

-42