Regarding the Lamp (Continued)
4
Remove the lamp unit.
• Loosen the securing screws from the lamp unit. Hold the lamp unit and pull it
in the direction of the arrow. At this time, keep the lamp unit horizontal and do not tilt it.
5
Insert the new lamp unit.
• Press the lamp unit firmly into the lamp unit compartment. Fasten the securing screws.
Securing screws
INTERLOCK
Warning!
DO NOT DEFEAT THIS INTERLOCK
6
Replace the lamp unit cover.
• Align the tab on the lamp unit cover (1) and place it while pressing the cover (2) to close it. Then tighten the user service screw (3) to secure the lamp unit cover.
Info
• If the lamp unit and lamp unit cover are |
| 1 |
not correctly installed, the power will |
| |
not turn on, even if the power cord is |
|
|
connected to the projector. | 2 | 3 |
|
|
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.
Info
•Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this | AC socket |
may cause the lamp to become damaged |
|
or explode. |
|
1
Connect the power cord and open the lens shutter fully.
• Plug the power cord into the AC socket of the projector.
2
Reset the lamp timer.
• While simultaneously holding down MENU, ENTER and R on the projector, press STANDBY/ON on the projector and keep all four buttons pressed down until the lamp indicator starts blinking green.
• “LAMP 0000 H” is displayed, indicating 
that the lamp timer is reset.
Lamp indicator
STANDBY/
ON button
ENTER
button 
R button
MENU button
-64
