Shindaiwa 82085 manual Setting The Saw Chain, Chain and Guide Bar Combinations, English, 326T

English

Chain and Guide Bar Combinations

The following combinations may be used on 326T.

Model	Bar Length	Low Kickback			Low Kickback Saw Chain
		Guard Bar
		Bar P/N	Chain P/N	Links		Type	Pitch	Gauge
	12”	120GPEA041	91VG-45	45
326T	14”	140GPEA041	91VG-52	52		91VG	3/8”	.050
	16”	160GPEA041	91VG-57	57

*Reduced nose radius symmetrical bars (OREGON name — Double Guard)

WARNING DANGER

Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may cause severe kickback resulting in serious injury.

Only use saw chain designated as “LOW-KICKBACK” that meets the ANSI B175.1-2000 Standard and the guide bar specified.

IMPORTANT

Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.

IMPORTANT

If your kick guard is damaged or lost, contact your Shindaiwa dealer for a replacement.

SETTING THE SAW CHAIN

For setting saw chains, round file (4 mm ø: 5/32”) and flat file are used.

■■To keep correct position and correct angle, use the file holder.

--Round file and flat file are available from your Shindaiwa Dealer. ■■File cutters as below.

	Type : 91VG	Depth gauge
30°		1/5
Keep this angle	90°
		ONE FIFTH OF FILE DIAMETER REMAINS
PUSH FILE AS SHOWN	HOLD FILE HOLDER LEVEL	ABOVE CUTTER EDGE

To sharpen other type chain, follow chain manufacturer’s instructions

24