Shindaiwa 81372, F222, T222 manual Product Description, Specifications, Prior to Assembly

Product Description

Using the accompanying illustrations as a guide, familiarize yourself with this unit and its various components. See Figure 4. Understanding your unit helps ensure top performance, long service life, and safer operation.

WARNING!

Do not make unauthorized modifications or alterations to any of these units or their components.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.

Specifications

T222

	Ignition	Grip
	Switch
	Handle
			Fuel
	Outer Tube	Throttle	Tank
		Trigger
Gear case	Cutting		F222
	Attachment Shield	Grip
	Ignition
	Switch
Trimmer	Handle
Head			Fuel
	Outer Tube	Throttle	Tank
		Trigger
Shaft case	Cutting
	Attachment Shield
	Trimmer Head

Figure 4

T222 dry weight
(less cutting attachment)	............................................10.8 lb./4.9 kg
F222 dry weight
(less cutting attachment)	............................................10.8 lb./4.9 kg
Engine model	S222E
Engine type	2-cycle catalyst
Bore x stroke	1.3 x 1.1 in./33 x 28 mm
Displacement	1.5 cu. in./23.9 cc
Maximum power	1 HP/0.8 kW
	@ 8000 rpm (min-1)
Fuel/oil ratio	50:1 with ISO-L-EGD or JASO FC
	class 2-cycle mixing oil*
Carburetor type	TK TZ, diaphragm-type
Fuel tank capacity	21.0 oz./620 ml

Ignition	One-piece electronic, transistor-controlled
Spark plug		BPMR6A
Air cleaner type	Non-reversible foam filter element
Starting method		Recoil
Stopping method		Slide switch
Transmission type	Automatic, centrifugal clutch
		w/bevel gear
EPA Emission Compliance Period**		............................ Category B

**The EPA emission compliance referred to on the emission compliance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category

C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

*meets or exceeds these specifications and is recommended for all Shindaiwa products.

Specifications are subject to change without notice.

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

■Engine and shaft assembly

■Cutting attachment shield

■Cutting attachment

■Kit containing cutting attachment shield, mounting bracket and hardware, this owner’s/operator’s manual and tool

kit for routine maintenance. Tool kits vary by model and may include a spark plug/screwdriver combination wrench, and a scraper.