Assembly and Adjustments
Cutting Attachment Shield
Socket- |
|
| T222 |
|
Head Cap | Outer |
|
| |
|
| Cutting | ||
Screw | Tube |
|
| |
|
|
| Attachment | |
Bracket |
|
|
| Shield |
|
|
|
| |
Shim |
|
|
| Nuts |
|
|
|
| |
Clamp |
|
|
|
|
Screw | Shim | Line Cutter |
|
|
|
|
|
| |
Cutting Attachment |
|
|
| |
Mounting | Plate |
|
|
|
Retaining |
|
|
|
|
Nut |
|
| 26013 | Hex |
Figure 9A |
|
|
| |
| Figure 9B | Screws | ||
F222 | Cutting |
Outer Tube | Attachment |
| Shield |
Cap |
|
| Locating Hole |
Screws |
|
Figure 9C |
|
Install the Cutting Attachment Shield T222.
1.Insert the cutting attachment shield between the outer tube and the cutting at- tachment mounting plate. See Figure 9A.
NOTE:
It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attachment shield mounting plate.
. Fit the two shims and the bracket over the outer tube and loosely install the four
Assembly
Trimmer Head
CAUTION!
Make sure the clamp screw and retaining nut are securely tightened before tightening the four
3.Tighten the four
4.
Install the Cutting Attachment Shield F222.
1.Install the shield and clamp as shown in figure 9B.
. Align the hole in the outer tube with the
locator on the cap; install the two (2) screws finger tight.
3.Tighten the screws alternately to secure the cutting attachment shield in place.
WARNING!
NEVER operate this unit without the cutting attachment shield installed and tightly secured!
Retaining
Plug
Holder
Output
shaft
Figure 10
Hex Wrench
1. Install the Trimmer Head.
. Turn the trimmer over so that the gear case output shaft faces UP.
3.Remove and discard the black plastic protective cap from the output shaft. See Figure 10.
4.Rotate the holder until the hole in the holder aligns with the notch on the gear case. Use the long end of the hex wrench to lock the holder and output shaft. See Figure 10.
5.Remove the hex wrench.
6.Adjust the trimmer line length to reach no further than the line cutter on the cutting attachment shield. Trim to the correct length if necessary.
The unit should now be
completely assembled and ready
for use with a trimmer head.
WARNING!
A standard grass trimmer with a loop handle should NEVER be operated with
