Introduction and Important Notes Nur für den internen Gebrauch
A31003-G2540-A100-3-76A9, 04/2003
1-8 optiClient 130 V4.0, User Manual
1einl.fm
Safety Information
●Install cables in such a way that they do not pose an accident risk (by people tripping over
them) and also so that they are not damaged.
1.3.4 General Notes●If the installation is brought into the operating site from a cold environment, condensation
may occur. Wait until the temperature of the installation has adjusted to the ambient tem-
perature and make sure that the system is absolutely dry before you start it.
●Before starting a wall assembly, check whether the load-bearing capacity of the wall is ad-
equate, e.g., in the case of dry walls.
●When maintenance work has been completed, always re-install all safety equipment in the
right place. Also close all doors, covers, or the housing after completing test and mainte-
nance work.
●All cables and lines which leave a system cabinet must be shielded at least between the
connection point in the cabinet and the point at which the cable leaves the cabinet.
Use a clip and pressure screw to contact all shield fabric to the cabinet outlet. This also
applies to permanently connected service equipment.
●Connect all cables only to the specified connection points.
●Do not install any external modems in the installation cabinets.