Convenient and secure telephone communication
18
kap01.fm5
27.11.98 Profiset 30isdn engl.: A30853-X300-B107-1-7619
Parking a call
You can temporarily park a call in order to
●reactivate it at a later stage
●resume it at another telephone
●unplug your telephone from one socket and plug it
into another
The telephone must not be parked for more than three
minutes, as otherwise the call will be disconnected.
Resuming a parked call
You can resume a parked call from the same telephone or
from a different telephone (it must be connected to the
same S0 bus).
Prerequisite: A call is parked and you are not conducting a
call.
dA call is in progress.
S04 Press the Programming key and enter the code “04“ for
“Parking a call“.
The stored connection code is indicated on the display.
The connection code is a number under which the call
can be parked and later resumed.
If the call is to be parked under a different connection
code, the connection code must have been changed
beforehand (➔page 34).
S and bPress the Programming key again and replace the hand-
set.
The call is now parked for a maximum period of 3 minutes.
A call can only be parked, if is connected to the
same S0 bus.
aHandset is on-hook.
S04 Press the Programming key and enter the code “04“ for
“Parking/resuming a call“.
The connection code is indicated on the display. If the call
was parked under a different connection code, change
the connection code beforehand (➔page 34).
S and cPress the Programming key again and lift the handset.
You are now re-connected to the parked caller.
You can cancel a programming procedure
without making any changes by pressing the
Disconnect key h !