right page (7) of AX72
Switch on/off, PIN | 7 |
VAR Language:
© Siemens AG 2003,
When charging is in progress his displayed.
Charging time
An empty battery is fully charged after about 2 hours. Charging is only possible within a temperature range of
+5 °C to +40 °C. If the temperature ris- es/falls 5 °C above/below this, the charge symbol flashes a warning. The mains voltage specified on the power supply unit must not be exceeded (Operating time, p. 35).
Charge icon not visible
If the battery has been discharged fully the charge icon is not immediately visible when the power supply unit is plugged in. It will appear after up to two hours. In this case the battery is fully charged after
Only use the power supply unit provided! Display while in service
Charge level displadgy uring operation
(empty - full):.
A beep sounds when the battery is nearly empty. The charge level of the battery is only displayed correctly after an uninter- rupted charging/discharging cycle. You should therefore not remove the battery un- necessarily and where possible not termi- nate the charging process early.
Switch on/off, PIN
Switch on/off
Press and hold the On/Off/End key B to switch on or off.
Enter PIN
The SIM card can be protected with a 4- to
Enter the PIN using the number keys. The characters **** appear to ensure no- body can read your PIN on the display. Correct errors with §Clear§.
Confirm your input with §OK§. Logging on to the network will take a few seconds.
Emergency number (SOS)
Only to be used in real emergencies!
By pressing the soft key §SOS§ you can make an emergency call on any network without a SIM card and without entering a PIN (not available in all countries).
Switching on your phone for the first time
Time/date
Set the clock to the right time once at
Press §Yes§. First enter the date (day/month/year), then the time
(24 hours, including seconds). Press §OK§. The time and date are updated.
If the battery is removed for longer than 30 seconds, the clock will be reset.
Time zones
Set the time zone for your area.
Select the required time zone from list with G. Apply with §Set§.
en; VAR issue date: 050613
