Siemens S7-300F-2 PN, DP manual 507

Industry Automation and Drive Technologies - SCE

Variable					Description
	Setting the MOBY Operating
		Value
				Operating Mode
			Default

IM Type

-; reserved for setting with switch or GSD parameterization: different interfaces without switch under- stand under MOBY mode = 0 the MOBY I_mode.

	MOBY I or MOBY E (without MDS	All
	507)
MOBY I with MDS 507
	MOBY U/D or RF300 – without multi tag handling
	Res. for MOBY U – with multi tag handling
	Reserved for MOBY D or RF300 - with multi tag
	handling (FB55)
MOBY F with MDS F1xx
	MOBY F with MDS F4xx
	MOBY F (reserved for MDS

To be noted:

MOBY_mode must only be changed after an IM is switched on

Scannung_time is the scanning time for the MDS 507 of MOBY I and MOBY V. For all other MDS types, the value 00 can be used.here. The figure below shows the setting for the scanning time (refer also to configguration manual for Reader 44/MDS 507):

Time value:00-3F

Time factor

Example: The result of a scanning time of 1 second = 81 hex for the parameter ABTA (scanning time)

Notes

__________________________________________________________________________

__________________________________________________________________________

__________________________________________________________________________

__________________________________________________________________________

__________________________________________________________________________

__________________________________________________________________________

__________________________________________________________________________

__________________________________________________________________________

TIA Training Document	Page 43 of 65
Module E11
Status: 01/2010	Radio Frequency Identification (RFID) with SIMATIC S7-300F-2PN/DP and
RF180C