How are alarm messages shown on the text display?
A single alarm message on the text display consists of 2 lines as shown in the example to the right.The first line tells that the alarm was given in zone 5 by the element 1 of this zone, which was an automatic fire detector. The numbers at the end of the line tell, that this is the first of in total 3 alarm messages. The se- cond line gives the explicit location of the re- sponding detector.
ALARM zone | ###/## / ###### | 1( | 3) |
1st floor | canteen |
|
|
ALARM zone ###/## / ###### | 3( | 3) | |
ground floor main entrance |
|
| |
|
|
|
|
The 3. and the 4. line hold the same information for the last alarm message issued. In this case a manual call point was actuated in zone 3 of the building, which is located in the ground floor main entrance.
1.alarm message zone 5, element 1 ”1st floor canteen”
3.alarm message zone 3, element 1 ”ground floor main entrance”
Scrolling alarm messages
Additional pending messages can be retrieved using the scroll key.
"Press the scroll key Ì below the text display.
Ü The first two lines are superseeded with the subsequent alarm message.
Retrieving supplementary informations
Supplementary informations to the alarm messages can be retrieved by using
F1
and
F2 :
n
n
F1
F2
tells the type of the responding device, e. g. automatic detector.
tells the cabling address and the type number of the responding device (device address).
"Press
F1
(or
F2 ).
Ü The second line in the text display is superseeded with the supplementary information.
"Press the scroll key to retrieve supplementary information of subsequent alarm messages.
How to respond in case of alarm
1.Press the Acknowledge key Í.
What to do after an alarm
"Reset system if normal conditions appeared.
"If a manual call point was activated while the alarm, insert a new front glass in the actual call point.
19
Fire & Security Products | |
Siemens Building Technologies Group | 02.2004 |
