Directory | Siemens HWCD8518(3)P/TSDL specification

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03

Press again the same key to delete the selected record.

Storing the incoming call numbers to the directory (base and handset)

Be sure the base and the handset is in standby.

Press CID		key.
Press	or	key to browse and select incoming call records.

Press the Mem/Prog key.

Then enter two digits (01-16) of the location where the number should be stored.

Note: the “0” in the “01” cannot be omitted.

Deleting a single incoming call number

Be sure the handset or the base is in standby.

Press CID		key.
Press	or	key to browse and select the incoming records.

Then press the Delete key on the handset or the base, and then the screen will display “Delete”.

Press “Delete” again to delete the selected record.

Deleting all incoming numbers

Be sure the handset or the base is in standby.

Press the CID

key.

Then long press the Flash/Clear key on the handset or the base.

Do not release it until the screen displays “Delete All”.

Press “Delete” again to delete all the records.

Browsing and dial the incoming numbers

Be sure the handset or the base is in standby.

Press CID		key.
Press	or	key to browse and select the incoming records.

If too long, press the 0/Turn Page (Next) key to display other records.

Then press the Talk key on the handset or the Hand-free/Dial Back key on the base to dial the selected number.

Directory

The handset and the base can respectively store 16 20-digit

17

Image 17

Siemens HWCD8518(3)P/TSDL user manual Directory, Deleting a single incoming call number, Deleting all incoming numbers

Contents

Expandable cordless phone system Be inspired Table of contents Appendix Interface Illustration Pack contains Installing the phonePreparing to use the phone Descriptions of displays of the handset Base Description of the function keys on the handset Descriptions of the function keys IndicatorsPage Tone/pulse switch SettingsFlash timing switch Setting the date and the time Adding IDD code to the incoming calls Handset and base Adjust the LCD light handset and baseAdding external mark to the incoming calls Handset and base Selecting Ringer Tones handset and base Select Caller Ringer Tones handset Base Selecting VIP Ringer Tones handset BaseRegistering the Handset INT Activating/deactivating Ringer Base Adjusting the ringer volume Adjust VolumeHandset and base Handset Making a Call Answering/Ending a callOutgoing call Last number redialing Basic operation Deleting a single outgoing number External call and power indicatorsDeleting all outgoing numbers Call ending function Base holding Intercom modeTransferring a call Searching for handset / base and intercom Transferring a call from the handset to the base Displaying incoming numbersTransferring a call from one handset to another Incoming call records Browsing incoming call records Deleting a single incoming call number DirectoryDeleting all incoming numbers Browsing and dial the incoming numbers Storing phone numbers Setting VIP callsBrowsing lists in the Directory Adding dialing pause Deleting all numbers in the Directory Dialing from stored caller-IDDeleting a single number in the Directory Parts of a long-distance number Location in the Directory Speed dialStoring IP numbers IP dialing and dial back Setting PIN and Lock CodePIN lock Unlocking Battery indicationMechanical lock Ringing back Safe use of the batteries Replacing batteriesIndicating information Care Calls Hotline Handset Base Top and side Base Bottom and Rear