Manuals / Siemens / Household Appliance / Thermostat

Siemens L-828 Regulation Environmental Operating Conditions, Temperature Range, Relative Humidity

Models: L-828

1 64

Download 64 pages 48.3 Kb

Page 20

L-828 CCRs LC-Type (4, 7.5, and 10 kW/6.6 A/60 Hz)

Description

Regulation

Environmental Operating Conditions

Refer to Table 2-8 for output current limits. Current regulation is obtained under the conditions listed in Environmental Operating Conditions.

The L-828 CCRs (4-10 kW/6.6 A) are designed for indoor use only in an area with adequate ventilation for cooling the constant current regulator. The environmental operating conditions include temperature range, relative humidity, and altitude.

	Temperature Range
	Without monitoring circuitry: -40 to +55 °C (-40 to +131 °F)
	With monitoring circuitry: 0 to +55 °C (-18 to +131 °F)
	Relative Humidity
	0 to 100% (noncondensing)
	Altitude
	Sea level to 6,600 ft (2000 m)
Protection Devices	L-828 CCRs have the following protection devices:
	• Output open-circuit protection
	• Output overcurrent protection
	• Lightning arrestors on output terminals and bushings
	• Fuse protection of remote control supply voltage (48 Vdc and
	120 Vac), and power supply for printed circuit board
	• Input breaker for supply voltage
	• W VA (load wattage in excess of maximum available volt-amperes
	Open-Circuit Protection
	The regulator includes an open-circuit protective device to open the
	primary switch within 2 seconds after an open circuit occurs in the
	secondary. The device resets within 2 seconds after the control
	switch is turned off and re-energized, and cannot be tripped by
	switching the load circuits or other transients.

 2002 Siemens Airfield Solutions, Incorporated	96A0104B	Page 2-8
All rights reserved	Issued 6/02

Image 20

Siemens L-828 Regulation Environmental Operating Conditions, Temperature Range, Relative Humidity, Altitude, Description

Contents

L-828Constant Current Regulators LC-Type 4, 7.5, and 10 kW/6.6 A/60 HzIssued: August 16, Rev. B: June 7, Document No. 96A0104Record of Changes PageDescription EC NoTable of Contents Safety DescriptionTable of Contents Installation Operation MaintenanceTroubleshooting Parts Wiring Schematics L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz List of Figures List of TablesTable of Contents L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz WarrantiesWarranties Warranties DisclaimersL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Section 1 Safety Safety1. Introduction 2. Safety Symbols L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Safety Symbols contd 3. Qualified PersonnelSafety L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz 4. Intended Use 5. InstallationSafety L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Installation contd 6. OperationSafety L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz 8.Maintenance and RepairSafety Section 2 Description Description1. Introduction L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz1. Introduction contd 2.L-828CCR Monitoring OptionsOptional Scanning Monitor Interface Optional Scanning Monitor Ready3. Indicators IndicatorL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Description4.Theory of Operation Introduction Silicon Control Rectifiers SCRsL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz DescriptionContactor Transformers5. 60 Hz LC-Type L-828CCRs 4-10kW/6.6 A: Required6.Input Power Breaker Sizing 7. SpecificationsRatings ClassStyle Power Factor Efficiency Reactive Loading Resistive LoadingNominal Output Power L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzRegulation Environmental Operating Conditions Temperature RangeRelative Humidity AltitudeBuilt-InTrue RMS-ReadingAmmeter Input Wire Size Overcurrent ProtectionMaximum Safe Overload Input Voltages Temperature RiseWeight CCR DimensionsL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz DescriptionSection Installation Installation1.Introduction 2.Unpacking 3.Installation Lifting CCR Mounting CCRRack Mounting InstallationL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz DescriptionWiring Connections and Startup Rack Mounting contdInstallation L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Wiring Connections and Startup contdInstallation Installation Figure 3-4Remote Control Wiring 3-StepFigure 3-5Remote Control Wiring 5-Step L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzInstallation Wiring Connections and Startup contdFigure 3-6Input/Output Wiring L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzInstallation Wiring Connections and Startup contdL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Terminal Block TB2 LabelInstallation Wiring Connections and Startup contdL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz If you use 3-StepCCR Remote IntensityWiring Connections and Startup contdInstallation L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzCalibrating Regulator IntroductionInstallation Wiring Connections and Startup contdSetting Up Regulator for Calibration Adjusting Output CurrentInstallation L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzAdjusting Output Current contd Adjusting OvercurrentInstallation L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Adjusting Overcurrent contdInstallation Section 4 Operation Operation1. Introduction 2. Local Control L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz2. Local Control Procedures 3. Remote Control 4. Shutdown ProcedureIf you set switch S1 L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzSection 5 Maintenance MaintenanceL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz 1. Introduction2. Maintenance Schedule MaintenanceMaintenance Task L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzShort-CircuitTest Open-CircuitTest Maintenance2. Maintenance Schedule L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzOpen-CircuitTest contd MaintenanceL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Section 6 Troubleshooting TroubleshootingL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz 1. Introduction2.Preliminary Troubleshooting TroubleshootingL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Circuit Breaker/Fuses3. General Troubleshooting ProceduresTroubleshooting L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz 4.General Troubleshooting Procedures contdTroubleshooting Troubleshooting 4.General Troubleshooting Procedures contdProblem L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzTroubleshooting 4.General Troubleshooting Procedures contdProblem 7. W VA-Indicatorred1.Introduction 2.Using the Illustrated Parts List Section 7 PartsParts L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzParts 3.L-828CCR 4-10kW/6.6 A Part Ordering CodeL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz 35B0462 L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzParts 35A0343 L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzParts L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Parts44D1475 47A0113 47A0108 49A0084 35A0438 53A0198 53A0212 53A0412-60 47A0117L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Parts35A0343 35A0290 44D1476-1 44D1476-2 32A0025 35B0462 35B0462-480 35B0463 35B0463-480 35B0464L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Parts33A0013 44B1712P 28A0011 28A0015 44A4824-1 Figure 7-2 LC-Type L-828CCR Component Parts 4ofAssembly 4-10kW/6.6 A Parts List contd4. L-828CCR General L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzAssembly 4-10kW/6.6 A Parts List contdL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz PartsAssembly 4-10kW/6.6 A Parts List contdL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz PartsAssembly 4-10kW/6.6 A Parts List contdL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz PartsAssembly 4-10kW/6.6 A Parts List contdL-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz Parts5.Recommended Spare Parts Recommended Spare Parts 4 kW/208-240VacRecommended Spare Parts 4 kW/480 Vac7.5 kW/480 Vac 10 kW/208-240Vac10 kW/480 Vac L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzSection Wiring Schematics Wiring SchematicsWiring Schematics L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzWiring Schematics L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 HzTBS4 TBS4Wiring Schematics L-828CCRs LC-Type4, 7.5, and 10 kW/6.6 A/60 Hz