Note – To store parameter changes, you can also power cycle the system using the front panel Power button.

After you disable the automatic system recovery (ASR) feature, it is not activated again until you re-enable it.

Obtaining Automatic System Recovery Information

Use the following procedure to retrieve information about the status of system components affected by automatic system recovery (ASR).

●At the sc> prompt, type:

sc> showcomponent

In the showcomponent command output, any devices marked disabled have been manually unconfigured using the system firmware. The showcomponent command also lists devices that have failed firmware diagnostics and have been automatically unconfigured by the system firmware.

For more information, see:

■“Automatic System Recovery” on page 30

■“Enabling and Disabling Automatic System Recovery” on page 33

■“To Disable Automatic System Recovery” on page 34

■“Unconfiguring and Reconfiguring Devices” on page 35

■“To Reconfigure a Device Manually” on page 36

Unconfiguring and Reconfiguring Devices

To support a degraded boot capability, the ALOM CMT firmware provides the disablecomponent command, which enables you to unconfigure system devices manually. This command flags the specified device as disabled by creating an entry in the ASR database.

Chapter 2 Managing RAS Features and System Firmware 35