Sierra Wireless 300 manual Q0 default Disable Quiet mode F1 default

DART 300 Migration Guide				Sample Configurations
Table 2-2 Host UDP Setup (client)
DART 200 Command	DART 300 Equivalent	Description
^A<ip>	+WPNEI=<ip>	Set the IP address (NEI) of the modem.
\N<s2>	+WS174=<s3>	Set the side preference. The direct translation of
		the side preference numbers is:
		s2	s3
		1	3	A Only
		2	4	B Only
		3	1	A Preferred
		4	2	B Preferred
\J0 (default)	+WPSPNI=<enter>	No channel restrictions, no SPNI matching.
\R4	+WS173=1	Use auto-registration mode.
S13=0	N/A	Continuous automatic registration. The
		DART 300 always uses continuous mode.
\O0	+WS45=0	Set (UDP) PAD mode.
*A0 (default)	S0=0 (manual answer)	No server required.
	+WS212=0 (disable server)
*L2100 (default)	+WS212=2100 (default)	Listen on port 2100.
S82=0	+WS217=0 (default)	Turn off UDP server receive lock. The
		DART 200 command also disables use of friends.
		The DART 300 disables friends if the list is empty
		(the default condition).
E0	E0	Command state echo off.
V0	V0	Use numeric result codes.
Q0 (default)	Q0 (default)	Disable Quiet mode.
F1 (default)	+WS62=0	Data state echo off.
X1 (default)	N/A	Extended result codes. The DART 300 will
		accept the X1 command but takes no action.
&C1 (default)	N/A	DCD follows state of connection. The DART 300
		uses this configuration and does not allow changes
		to DCD function.
&D0 (default)	&D0	Ignore DTR.
&E2	S2=43 (Sets TDES escape	Enable the escape sequence and filter it from the
	character to “+”) (default)	packet. The DART 300 ensures TDES is enabled;
		the DART 300 always filters it from the packet.
&S0 (default)	N/A	DSR always active. The DART 300 always
		asserts DSR.
\F3 (default)	Not needed, the next command	Includes PAD forwarding character in packet.
	would change the setting.
\M0 (default)	+WS63=0	Disables PAD forwarding character.

2110291 Rev 1.0 Page 5