Sierra Wireless 300 manual With +WPCHAN Ln = +WPCHAN=n = +WPCHAN=0

DART 300 Migration Guide		Comparative AT Command Reference
Table 4-5: AT [^] Commands (continued)
Command	DART 200	DART 300 Equivalent
^L	LASI and WASI Set	LASI and WASI Set
	Sets the LASI/WASI value into one of the 10	Not supported.
	slots in the DART’s table.
^P	Personalization Mode	Personalization Mode
	This command must be issued before any other	Not supported.
	Service Provider commands can be executed.
^S	SLIP Address Set	SLIP Address Set
	Sets the SLIP IP Address of the Modem. This	Not supported.
	internal address is a private address between
	the modem and the terminal connected to the
	serial port and is unknown to the network.

The Minus (-) command set is only available on the DART 200. The DART 300 uses alternative commands or registers where equivalent functions exist.

Table 4-6: AT [-] Commands

Command	DART 200	DART 300 Equivalent
-L	Lock Specific Channel	Set Modem Channel
	Override normal Radio Resource Management	Channel locking and scanning is controlled
	functions and lock onto a specific channel.	with +WPCHAN.
		-L<n> = +WPCHAN=<n>
		-L- = +WPCHAN=0	(unlock)
-R	Reboot	Reset
	Restarts the DART 200.	The DART 300 is reset with +WVRESET.
-V	View Radio Source Management Data	View Radio Source Management Data
	Displays the current value of pertinent Radio	Not supported.
	Resource Management Data. See the
	DART 200 User Guide for details.
-Z	Display Current Authentication Credentials	Display Current Authentication Credentials
	Shows the current values for the ASN	Not supported.
	(sequential) and ARN (random) authentication
	numbers.

2110291 Rev 1.0 Page 28