Sierra Wireless 300 +WPREG and +WPDEREG, R0, R1, R2, R3, R4 = +WS173=1 \R5 = +WS173=0, = +WS45=1

DART 300 Migration Guide			Comparative AT Command Reference
Table 4-3: AT [\] Commands (continued)
Command	DART 200	DART 300 Equivalent
\R	Registration Control	Registration Control
	Controls the modem’s CDPD network	The DART 300 controls registration with a
	registration. Auto-registration is controlled by	combination of +WS173 and commands
	a combination of \R4 and S13=0.	+WPREG and +WPDEREG.
	S13 controls the registration timeout.	Register +WS198 controls the registration
	See the DART 200 User Guide for details.	process timeout.
		\R0	= +WPDEREG
		\R1	= +WPREG
		\R2	= not supported (H1 can be used to
		\R3	deregister when session is closed.)
			= not supported
		\R4	= +WS173=1
		\R5	= +WS173=0
\S	Subscriber Identity	Subscriber Identity
	Displays the modem's NEI (IP Address), used	Setting the NEI is managed with register
	to select the NEI to be used for network	+WS197 and the command +WPNEI.
	registration, and also used to display the SPNI	Selecting the NEI to register is controlled with
	list.	+WS197 (manual registration) and +WS176
	It supports both point-to-point (normal) and	(auto-registration).
	multicast (if being used) IP Addresses. The	SPNI list display is available using
	CDPD Service Provider provides the IP	+WPSPNI?.
	addresses.	For details on Broadcast and Multicast, consult
	See the DART 200 User Guide for details.
		the DART 300 User Guide.
\T	Automatic Transmit Control	PAD Inter-Character Timer
	Enables the inter-character timer (S50) for	+WS70 sets the inter-character timeout. A
	data forwarding.	setting of zero disables it.
		\T0	= +WS70=0
		\T1	= +WS70=t (where t is the setting
		used in S50 of the DART 200).

The Asterisk (*) command set is only available on the DART 200. The DART 300 uses alternative commands or registers where equivalent functionality exists.

Table 4-4: AT [*] Commands

Command	DART 200	DART 300 Equivalent
*A	Server Type	Server Type
	Specifies the type of server to be used: TCP or	The DART 300 selects packet service for both
	UDP.	client and server sessions.
		*A0	= S0=0+WS212=0		(no server)
		*A1	= +WS45=1	(TCP)
		*A2	= +WS45=0	(UDP)
*B	Broadcast Reception Control	Consult the DART 300 User Guide for details
	Enables or disables the reception of IP	on Broadcast application.
	broadcast packets.

2110291 Rev 1.0 Page 25